Plumbing Service In Chino, CA

JIG Plumbing came out to replace the elongated toilet and install a new emergency shutoff valve.

JIG Plumbing will diagnose, inspect, and troubleshoot the tankless water heater to determine the cause of the issue. This service does not include parts or part replacement. If the issue cannot be resolved during the diagnostic visit, JIG Plumbing will provide the customer with repair options and pricing. JIG Plumbing successfully diagnosed and confirmed the issue with the tankless water heater. Navien will be sending a replacement heat exchanger, which is expected to arrive within one business day. Once the part is received, JIG Plumbing will return to replace the heat exchanger. Parts and labor are included.

JIG Plumbing will supply and install a new Rinnai tankless water heater. Technician will remove the existing tankless heater, and install a new Rinnai in its place, as well as a new set of isolation valves, and a new scale inhibitor. Technician will test the unit thoroughly upon completion to ensure proper functionality.

JIG Plumbing came out to cable, mini-jet, and descale the 2” kitchen drain, which had significant grease buildup over time. We were able to remove all of the white grease buildup from the line and restore proper flow. Due to the previous buildup, we recommend having the system flushed once a year, or at minimum every two years, to help prevent future blockages. We also replaced the 1” PRV with a direct swap-out. New Membership: Customer enrolled in the JIG Pro Plan, providing ongoing plumbing maintenance and service benefits.

Scope of Work JIG Plumbing came out to tighten the loose shower handle at no charge. We also performed mini-jetting through three accessible exterior cleanouts to clear the secondary drain lines serving the master bathroom dual sinks and kitchen. Following the jetting service, we performed a thorough camera inspection through all three 2” cleanouts to verify the condition and flow of the secondary drain lines.

JIG Plumbing technician came out to flush the tank-type water heater. We also replaced the existing 1-1/4” shutoff valve with a new 1-1/4” pressure-reducing valve (PRV). The water pressure was adjusted and set to 75 PSI.

Scope of Work: JIG Plumbing will replace the existing 50-gallon water heater as a direct swap. We will also replace the existing 3/4” shutoff valve and install new hot and cold water supply lines. A new water heater pan will be installed, and the T&P relief valve discharge will be rerouted directly into the pan using 3/4” PVC. Recommendation – Expansion Tank: JIG Plumbing recommends installing an expansion tank to help absorb thermal expansion and reduce pressure spikes within the plumbing system. This helps protect the water heater and plumbing components and can extend the life of the system.

JIG Plumbing will perform a mainline sewer inspection in order to determine the integrity of the line. All images will be recorded, and any issues will be addressed, and repairs will be submitted in a separate estimate.

JIG Plumbing will open the ceiling to diagnose the issue. Once the ceiling is open, we will work to provide proper recommendations for a repair. The technician found the shower arm riser to be leaking. We will open the drywall behind the shower arm, remove all 2x4s in the way and replace the shower arm and riser with new components. We will then secure the new shower arm riser in place. We will check for leaks when finished. After removing the shower arm, the technician found that only the shower arm was damaged. The technician replaced the shower arm and checked for leaks. There are no leaks at this time. JIG Plumbing applied a discount for the reduced scope of work.

Arrived to Provide Customer with an Estimate.

The technicians arrived on site to inspect a leak at the kitchen sink drainage. The customer informed the technicians that he and a friend had recently installed the new kitchen sink themselves, along with the kitchen faucet, air gap, RO faucet and reconnection, and garbage disposal. When attempting to connect the drainage, they experienced leaking from the tubular P-trap due to the offset angle at which it had been installed. The technicians also found that the air gap-to-garbage disposal hose was kinked in two locations, restricting proper flow. Per the customer’s request, the technicians removed and replaced the tubular P-trap and replaced the air gap-to-garbage disposal hose. The drainage components were properly aligned and adjusted to allow for smooth flow while eliminating unnecessary stress on the connections. The technicians also repositioned and tightened the kitchen faucet for the customer. Upon completion, the technicians tested the repaired connections for proper drainage

JIG Plumbing will perform a tankless water heater flush on a Noritz tankless water heater, ensuring proper functionality.

JIG Plumbing will perform drain cleaning through cleanout access in order remove an obstruction. Once cleared, the line will be tested to ensure proper functionality of drain system.

JIG Plumbing will install two new customer supplied faucets. One will be for the hallway restroom, and the other for the kitchen sink. In addition, three emergency stops will be replaced at time of faucet installation, due to age and condition. Two supply lines will be installed for the hallway restroom. Once completed, all items will be inspected to ensure proper functionality.

The technicians arrived on site to inspect the source of a foul odor coming from the downstairs bathroom. The tenant stated that the lavatory sink produced a foul smell whenever it was used and that the shower also emitted an odor during use. The tenant advised that this issue had been ongoing for some time. The technicians were also informed that the toilet had experienced a stoppage the previous day and overflowed, but the tenant was able to clear the blockage using a plunger. During the inspection, the technicians found that the toilet was continuously running due to a failed flapper. They also discovered that the lavatory sink’s tubular drain assembly was missing a gasket, causing the drain to leak beneath the sink. This leak had allowed wastewater to accumulate inside the vanity cabinet, significantly contributing to the foul odor. Upon customer approval, the technicians replaced the lavatory sink tubular drain assembly, thoroughly cleaned the pop-up assembly, and cleaned the bo

The technicians arrived on site and performed a partial rebuild of the toilet tank to restore proper operation and replace worn or damaged components. The work included installing a new toilet fill valve with a new supply line, replacing the Mansfield flush valve gasket, and installing a new toilet handle due to the existing handle being broken. During the repair, the technicians found that the existing multi-turn emergency shut-off valve would not fully shut off the water and leaked when placed in the off position. The customer elected not to replace the shut-off valve at this time. To complete the repair, the technicians isolated the water supply by shutting off the isolation valve located above the bathroom ceiling inside the warehouse. Once the repairs were completed, the technicians restored the water supply and thoroughly tested the toilet. At this time, the newly installed toilet tank components are operating properly. Disclaimer – Toilet Emergency Shut-Off Valve The existin

The technicians arrived on site to inspect why the irrigation ball valve would not shut off. The irrigation ball valve and pressure regulator, which were installed by JIG Plumbing approximately three years ago, are located in an irrigation valve box next to the water meter. Upon inspection, the technicians found that the irrigation box was completely full of water, causing corrosion on the ball valve handle and the pressure regulator adjustment screw. The technicians removed roots from the valve box, excavated and removed a significant amount of mud, drained the standing water, and thoroughly cleaned the area. They then inspected the ball valve and pressure regulator to verify that neither component was leaking. As a complimentary service, the technicians applied WD-40 to the ball valve handle and the regulator adjustment screw to remove corrosion and restore proper operation. After cleaning and lubricating the components, the ball valve operated smoothly and shut off properly. The t

The technicians arrived on site to install the customer’s customer-supplied Brio Moderna Series Four-Stage Reverse Osmosis Filtered Ice Plus Hot/Cold Water Dispenser in the designated location next to the pantry. To complete the installation, the technicians routed new reverse osmosis water supply tubing and drain tubing from the kitchen sink area, running the lines behind the dishwasher and through the back of the pantry to the dispenser location. All tubing was installed neatly and securely while minimizing its visibility. The technicians connected the reverse osmosis system to the home’s cold water supply, installed the required drain connection, connected the dispenser, and verified that all plumbing and electrical connections were properly aligned. Once the installation was complete, the technicians flushed the reverse osmosis filtration system in accordance with the manufacturer’s recommended startup procedure. The technicians tested the hot, cold, ambient, and filtered water fu

The technicians arrived on site to remove and reset the toilet due to a leak affecting the downstairs ceiling. Once the toilet was pulled, the technicians were able to confirm that the existing wax ring had washed out around the top, allowing water to escape during flushing and leak into the downstairs ceiling. The old wax ring and mounting hardware were removed, and a new wax ring and new closet bolts were installed. The toilet was then reset, properly secured, and thoroughly tested by flushing multiple times while inspecting for leaks. At this time, the toilet is secure, operating properly, and no leaks were found.

Upon arrival, two toilets have major discoloration around the bas of the toilets, the half-bath hall toilet and the master toilet. The master toilet has worse discoloration. There is a small leak at a gasket underneath the kitchen sink on the drain line. The garbage disposal is corroded and has an item inside that causes an awe full noise when the disposal runs. Additionally, the shower head bracket is broken in the full-hall bathroom. JIG Plumbing will perform a meter test where we will isolate the gas valves that are accessible and we will check for gas leaks. This test does not locate any leaks, it only tells us whether or not there is a leak. If a gas leak is present, we will provide options to locate the leak. The test concluded there are no gas leaks at this time. If other customers report the smell of gas, it is recommended to investigate the exhaust systems of the gas appliances.

JIG Plumbing will remove piping from the T&P valve in order to determine what the root cause of the leak is. Once diagnosed, the technician will formulate an appropriate solution in order to correct the issue. JIG Plumbing will preventatively replace the relief valve on your tankless to see if this solves the issue. Replacing the relief valve has completely solved the issue. The relief line is no longer dripping. At the time of service, JIG Plumbing will flush your tankless water heater as a part of preventative maintenance. If any issues become apparent in the flushing process, we will provide options for repair.

JIG Plumbing rebuilt the home’s main service tree, reducing the water service from 1-inch to 3/4-inch to properly match the home’s plumbing system. Work performed includes: * Installed a new 1-inch main shutoff valve for the residence. * Installed a new 3/4-inch shutoff valve dedicated to the irrigation system. * Installed a new 1-inch pressure reducing valve (PRV). * Installed a new 3/4-inch hose bib. * Adjusted and tested the pressure reducing valve to 70 PSI, ensuring proper operating water pressure throughout the home. Upon completion, the new service tree was tested and found to be operating properly with no leaks observed at the time of service.

JIG Plumbing removed and replaced the home's full pressure regulating valve (PRV) service tree with new 1-inch copper piping. The installation included: * New 1-inch pressure reducing valve (PRV) * Two new 1-inch ball shutoff valves (irrigation and main service line to the home) * New 3/4-inch hose bib * Reconnection of all existing service line piping All new components were installed, tested for proper operation, and checked for leaks. The new service tree is functioning properly and provides reliable isolation of both the irrigation system and the home's main water supply. New water pressure adjusted at 75PSI. NEW 1" prv with 2 ball valves and hose bib.

JIG Plumbing installed the customer-supplied Moen tub/shower cartridge. We cleared the bathtub drain line using an electric drain snake. As a courtesy, we also cleared the lavatory sink drain in the same third-floor bathroom. Findings: The bathtub drain had a heavy restriction. Multiple attempts were made to clear a hard obstruction, which significantly restricted drainage. While the drain flow improved, the obstruction appears to remain present and may require additional diagnostics or further drain cleaning if the issue recurs.

Upon arrival, the water pressure at the fixtures are low when multiple fixtures are running. This was solved when the whole house filter was put on bypass. Additionally, the customer has requested the pressure be increased to the home. All shut off valves and fixtures are operational at this time. However, the water heater pan does not outlet anywhere. A leak detector is recommended. Based on the pipe in the meter box, the water service appears to be galvanized pipe. Replacement is recommended. Additionally, we will increase the setting on the regulator at no additional charge. JIG Plumbing will install the customer provided filter. We will check for leaks when finished.